Power Distribution Equipment

1. Home
2. Products
3. Electronic & Electrical
4. Power Distribution Equipment

Share us

500KV Guyed Dead end corner structure

MGP-500GDECS

Send Inquiry

Description

500 kV Guyed dead end-corner structure
Dead-end tower, also named anchor tower or anchor pylon, uses horizontal strain insulators and occur at the endpoints of conductors. Such endpoints are necessary when interfacing with other modes of power transmission and, due to the inflexibility of the conductors, when significantly altering the direction of the tower line. Dead-end towers are also employed at branch points as branch pylons. A tower at which the power line runs further as overhead line and as underground cable is a branch tower for a cable branch. Sometimes, in order to withstand the strong loading or wind speed, we need design guyed delta structure. Guyed towers are utilized to achieve the maximum in elevation and loading at an economical cost. The addition of heavier braced sections and torque arm guy points allow a tower to be engineered custom to its loading specifications. Guyed tower can withstand high tension or wind loading during power transmission lines.
MEGATRO provide Series 500 kV Guyed dead end-corner structure at a much lower material cost than self supporting towers due to the efficient use of steel guy lines, The guyed lattice masts are normally guyed in three directions equally spaced 120 degrees apart over an anchor radius of typically 2/3 of the tower height, The mast construction consists of triangular lattice modular section, each module fully welded tubular leg and solid round bar bracing incorporating integral step rungs fabricated into the lattice framework on one face this removes the need for a separate ladder. all masts sections are hot dipped galvanized after fabrication. Mast heights range 9 up to 50 meters, these masts can also be Etched primed and powder coated as an optional extra if required

Read More