Electronics Designing & Processing

1. Home
2. Products
3. Electronic & Electrical
4. Electronics Designing & Processing

Share us

10 X 5 Galvanized Tandem Trailer , Tradesman Cargo Utility Trailers

10x5

Send Inquiry

Description

?10x5 tandem axle hot dipped galvanized cage trailer
?Competitive Advantage:

Extra Features Included
Rocker Roller Springs
Tube Holder In Each Corner
Full Lengh Side Tie Rails/Deflection Rails
Fully Hot Dipped Gavanised

Specifications:

- - - -
BODY/FLOOR | 350MM Sides 2 piece 2.1mm Rolled Checker Plate Tub |
TAILGATES | 2.1mm Folded Checker Plate, with tie rails |
MUDGARD | 2.1mm Checker Plate, 250mm Wide 4 Fold |
DEFLECTION RAILS | 50x50 Angle on each side |
SIDE TIE RAILS | 27x2mm Pipe Round Full Length (extra reinforced) |
COUPLING | 50mm Mechanical over Ride Plunger Type / Hand Brake |
SUSPENSION | Rocker Roller Load Sharing Springs |
AXLES/BRAKES | 40mm Square Solid/ Mechanical Disc |
BRAKES | Mechanical Disc/Galvanised Calliper’s True Cable Hand Brake |
HUBS/FORD | LM A-type PCD 114.3, 5 x 1/2& quot; Studs (Stud Centre 66.6mm) |
BEARINGS | Bearing A-type Inner Large LM67048 Outer Small LM11949 |
RIMS | NEW Sunraysia Type 14x5.5& quot; CB 84mm PCD 114.3 (FORD) |
TYRES | NEW 185R14C |
CHASSIS | ALL50x50 RHS |
DRAW BAR | 100x50x3mm RHS V-type, with spare wheel holder |
SAFETY CHAIN | 10mm Rated chain 450mm Long |
LIGHTS | LED Multi volt 12-24v, With Side Clearance Lights 7-Pin plug |
- - - -

?
?
Description:
?
STANDARD FEATURES
· Rolled C/Plate floor with 350mm High Side
· Front & rear opening tailgates with tie rails
· C/Plate Tailgates & Mudguards
· Full length side tie rails with Deflection Rails
· Swing handles to secure the tailgates
· V- type draw bar made from square RHS tube
· Spare Wheel Holder on Draw Bar
· Lockable plunger coupling
· LED ADR approved lights and reflectors/ Light protectors
· Mudflaps to comply with Australian standards
· New wheels (NOTE NOT SECOND HAND)
· Plug holder fitted on draw bar
· Mechanical disk brakes /Cable hand brake fitted
· Tube holders in each corner for fitting cage or H/frame
?
?
?
After service:
1) We Will Offer Completely Assembly Drawing To Customer After We Finish Loading Container
2) We Will Offer Completely Components List To Customer, Easy For Checking Quantity For Trailer And Trailer Parts In The Container.
3) We Will Speed Post Small Parts To Customers If Any Parts Have Problems Under Our Warranty. We Will Take Whole Cost.
4) We Will Send Big Parts Into Next Container If Any Parts Have Problems Under Our Warranty.
Customer Also Can Buy The Parts From Local If It Is Urgently And Can Not Wait For Us Sending Parts To Them. We Will Take Whole Cost.
5) We Are Very Happy Make Some Other Products To Our Customers If They Need Them.
6) We Can Put Customers Good Into Container If They Have Any Products From Other Supplier.
7) We Will Give A Very Good Preferential Policies To The Customers Whom Do Business With Us More Than A Year. Or More Than 6 Containers.
We Will Help Every New Customers Start Trailers Business.

Read More