Photographic & Sensitive Products
Description
?
Exterior Heat Resistant Mosaic Tile Adhesive Waterproof For Decorative
?
?
Cement-based polymer adhesive specially for bonding sandstone on interior and exterior wall and floor. Sandstone is low strength, not so heavy, low water-absorption and becomes black and mildewed when meets alkali. PB-04 is high bonding strength, low alkali and avoids the sandstone becoming black and mildewed. Suitable for bonding sandstone on cement mortar, concrete, Eterpan etc such strong substrates.
?
?
Features:? ???
?
1, A new type strong stone adhesive, applied to all kinds of low water-absorption stone materials like large-sized artificial stones, culture stones, and natural stones.
?
2, No need to wet the brick wall, effectively improve the efficiency.
?
3, Strong bond ability, material-saving, much safer and firmer than the traditional cement adhesive, also can reduce the construct trash and the weight of the wall.
?
4, Good anti-acid, anti-alkali, anti-infiltration and anti-aging function.
?
5, Small shrinking rate, no cracking, can be used in cold and humid environment.
?
?
Application:
?
1, The adhesive for the cement plaster, brick and smooth cement surface.
?
2, The adhesive for low water-absorption surface and light weight board, like Eterpan, Pine Board and gypsum board.??
?
?
Surface Treatment:
?
The substrate surface should be firm, dry and clean, no grease, no wax, and other loose materials.
?
?
Operation Process:
?
1, The ratio: PB-04: water=3.3: 1 (20kg powder, about 6kg water). Mixing and stirring them into paste, using an electric mixer to make uniform paste, put it aside for a few minutes and then a little stirring to gain the better effect.
?
2, Using tooth scraper to scrap the adhesive onto the surface evenly, control within 1㎡, then push the stone above it.
?
3, For the tile or stone material with deep ditch, not only scrape the surface, but also the backside of ?the tile or stone.??
?
?
Normal Amount:
?
- - - -
Size of notched trowel | Coverage(kg/m2) | Technical parameter |
3mm×3mm | 1.7 kg/㎡ | Adjusting time: 15 minutes |
Hardening time: 10 minutes |
6mm×6mm | 3.0 kg/㎡ | Full curing time: 24 hours |
Waterproof; non-toxic |
10mm×10mm | 4.5 kg/㎡ | Resistance to acids and alkali |
Shearing strength >1.5MPA(14days) |
- - - -
?
?
Tips:
?
Bricks for wall using 3×3mm tooth scraper or 6×6mm tooth scraper.
?
Bricks for floor using 6×6mm tooth scraper or 10×10mm tooth scraper.
?
?
Cautions:
?
1, Make sure the smooth and vertical rate of the surface before operation.
?
2, Never mix the dry slurry with water for second use.
?
3, Check the mortar layer of the back side, make sure that have no cavitation.
?
4, Can not be walked on or filled crack unless finished after 24h.
?
?
Store Method:
?
Store in cool and dry place, unopened product can be saved for one year.
?
?
Packing:
?
20kg/bag
?
Read More
Guangzhou Pinbang Building lndustrial company limited
Ceramic Wall Tile Adhesive(21),Ceramic Floor Tile Adhesive(12),Marble Tile Adhesive(15)
Address: Room A601, Yangcheng Garden, Zhongshan Avenue,
tianhe, guangzhou
China, 510000
Tel: 86-020-32026839
Fax: 86-020-32026839
